TV Wall Mount Installation: Brackets, Walls & Cables
🏠 Renovation🏢 Office Fit-Out🛍 Shop Fit-Out💦 Waterproofing❄ Aircon⚡ Electrical & Plumbing🔨 Carpentry🧹 Deep CleaningGuidesDesign IdeasToolsAbout🔍 SearchFree Quote
📺 TV Wall Mount

TV Wall Mount Installation
Brackets, Walls & Cables (2026)

How to get a TV safely onto the wall: the bracket, the wall behind it, the height and the cables.

📍 We serve KL, Selangor & Putrajaya.

Flat-screen TV mounted on a living room wall above a floating console with no visible cables

Mounting a TV on the wall is a small job that depends on two things you cannot see: what the wall is made of and where the cables run inside it. On concrete or solid brick a bracket holds well; on lightweight block it needs anchors made for that block; on plasterboard it must be fixed through to the structure or to backing behind the board. Then decide the height and how the cables will be hidden. ClickBina's handyman price list puts TV wall mounting at RM80 – RM200, bracket excluded and concealed cabling extra (indicative 2026, Klang Valley).

TV stand or wall mount: which suits your room

Before choosing a bracket, decide whether the TV should go on the wall at all. Our living room design guide suggests wall-mounting the TV and floating the console in a small condo living room, because it saves floor space and makes the room look lighter. A stand or console is still the right answer in some homes.

SituationWall mountStand or console
Small living room, want floor spaceBetter: nothing on the floorTakes floor area
Wall is plasterboard or doubtfulOnly with backing or fixing into structureSimpler: the floor carries the weight
Rented homeLeaves bolt holes to repair at handoverNo holes in the wall
Children who climb furnitureTV is out of reach and cannot tipStrap the TV and console to the wall
TV is moved or swapped oftenNew TVs may need a different bracketJust lift and replace

If you choose a console, our TV cabinet cost guide explains why a floating console has the same wall problem as a bracket, and when a floor-standing console is the cheaper answer.

Bracket types compared

There are three common bracket types. The further the TV sits from the wall, the more leverage it puts on the fixings. Our wall plugs and anchors guide puts it plainly: a TV bracket puts a lever on the wall, and more so when it is a swing arm pulled out from the wall.

BracketWhat it doesBest forWatch out for
Fixed (flat)Holds the TV close to the wallTV directly opposite the sofaLittle room behind the TV for plugs
TiltingAngles the screen up or downTV mounted a little higher than eye levelSlightly more leverage than fixed
Full-motion (swing arm)Pulls out and turns the TVCorner seating, open-plan roomsMost leverage; needs the strongest wall

Check that the bracket matches the hole pattern on the back of your TV and the TV's weight, as stated by the bracket maker. On a lightweight block wall, the anchors guide advises spreading the fixings and preferring a fixed bracket to a long swing arm.

Check the wall before anything is drilled

Most of the risk in a TV mount is the wall, not the bracket. A Malaysian living room can have a concrete column, a lightweight block wall and a plasterboard bulkhead a few steps apart, so the exact spot matters. Knock on it: a dull, solid sound is masonry; a hollow sound is board.

WallHow to recognise itWhat the TV mount needs
ConcreteVery hard to drill, grey dustThe strongest base; fix into sound concrete, not plaster alone
Solid brickRed or grey dust, drill bites steadilyGood with the right plug; avoid the mortar joints
Lightweight AAC blockDrills very easily, fine pale dustAnchors made for aerated concrete, fixings spread out
Plasterboard partitionSounds hollow; the drill breaks into a voidFix through to studs or to backing anchored to structure

The bracket makers say the same. Our TV cabinet guide quotes Vogel's installation manual: the fixings supplied with a TV wall mount are intended for solid brick, solid concrete or solid wood columns only, and hollow brick, wood panel or plasterboard walls require specialist advice. The same guide quotes one anchor maker's dedicated plasterboard fixing at a maximum of 8 kg in 12.5 mm board: fine for a light frame, not for a TV.

Plasterboard, false walls and feature walls

Condo partitions, bulkheads and TV feature walls are often plasterboard on a metal frame. A TV can go on them, but only when the load is carried by something stronger than the board. Our false wall cost guide says a false wall can hold a TV provided the bracket point is reinforced with a backing board (19 mm plywood or timber block) behind the gypsum layer, and that standard board alone is not enough for large TVs.

  • If the wall is still being built, tell the contractor the TV size and bracket type before boarding, so the backing goes in the right place.
  • If the wall is already finished, the fixings go through the board into the studs or into the solid wall behind, or the TV moves to a solid wall.
  • A TV feature wall is the natural place to plan the backing, the TV point and the cable route together; see our TV feature wall cost guide.

How high to mount the TV

The most common mistake is mounting the TV too high. Our TV cabinet size guide gives the rule that matters: keep the screen centre close to seated eye level. A wall-mounted TV lined up with a feature wall or a tall cabinet often ends up higher still, which is uncomfortable to watch from the sofa.

  1. Sit where you normally watch and note where your eyes fall on the wall.
  2. Aim to put the middle of the screen near that point, not the top or bottom edge.
  3. Mark the TV outline on the wall with tape before drilling, and check it from the sofa.
  4. If the TV must go higher, for example above a console with a soundbar, a tilting bracket helps.
  5. Fix the height before the TV point and the cable outlet are placed, because they sit behind the screen.

How far the sofa should be from the screen is a separate question; the viewing distance section of our TV cabinet guide explains it with the broadcast standards.

Hiding the cables: trunking, conduit or a false wall

A mounted TV with cables hanging below it is the result most owners want to avoid. There are three ways to deal with them, and they differ in cost, mess and permanence.

MethodHow it worksGood forLimits
Surface trunkingA plastic channel on the wall surface, painted to matchRented homes, quick jobsStill visible; easy to change later
Concealed conduitA groove cut in the wall, conduit laid with a draw wire, plastered overOwner-occupied homes before repaintingPermanent; needs planning and making good
Behind a false wallCables run in the cavity behind the boardTV feature wallsPoints must be placed before boarding

Our TV and Astro cabling guide recommends deciding the TV height and position first, then putting the TV, power and data points behind the screen, with a low-level conduit down to the cabinet for the decoder and other boxes. The TV feature wall guide adds that the power point should sit directly behind the mounting area, not to the side. Moving or adding a socket is electrical work with its own scope, so include it in the quote rather than leaving it to the mounting visit.

Drilling safely: cables, pipes and condo rules

Drilling is where a simple job can turn into a repair. The anchors guide lists the hazards:

  • Concealed wiring usually runs straight up or down from sockets and switches, so avoid those lines and use a detector.
  • Water pipes run in walls near kitchens and bathrooms; a drilled pipe is a leak inside the wall.
  • Tiles need a tile or diamond bit, started without hammer action.
  • Fixings into a mortar joint between bricks have nothing firm to grip.
  • In a condo, check the building's renovation rules first: many restrict noisy work to set hours.

If a drill hits a cable, do not touch the bit or the wall: switch off the main switch at the distribution board and have the circuit checked before it is switched back on.

What TV wall mounting costs

These are indicative Klang Valley figures from ClickBina's guides (2026). The mounting price is labour; the bracket is bought separately, and cable work is quoted on top.

JobIndicative price (2026)Notes
TV wall mountingRM80 – RM200Bracket excluded; concealed cabling extra (handyman price list)
Basic TV wall: plywood base, laminate or paint finish, TV mount, conduitRM3,000 – RM6,000When the wall itself is being built (TV and Astro cabling guide)

Want this priced for your home?

WhatsApp us your job details for a quote — we reply within the hour. A site visit is free. We serve KL, Selangor & Putrajaya.

💬 WhatsApp for a quote
Reply within the hourFlat price, no hidden chargesExperienced KL & Selangor contractor

What moves the price within the range: the wall type, a swing arm versus a fixed bracket, the TV size, tiles or cladding to drill through, and whether a new point or concealed conduit is needed. Several small jobs such as curtain rods and shelves are cheaper done in the same visit.

Taking a TV bracket down

A bracket that comes off leaves a cluster of large holes. Our wall hole patching guide explains the repair: on masonry each hole is filled and the area skimmed so it reads as one surface; on gypsum board a section with the face pulled out is cut out and patched. In a rented home, bracket holes are among the most common items at handover, which is one more reason tenants often choose a stand.

How ClickBina can help

WhatsApp us your job details for a quote: the TV size, the bracket if you have bought it, what the wall sounds like when you knock on it, and whether the cables should be hidden. ClickBina is an experienced KL & Selangor contractor that handles whole-house refurbishment and coordinates the trades, so the wall, the backing, the cable route and the mounting can be planned together. We reply within the hour, and the price we agree is a flat price with no hidden charges.

Sources & methodology

  • ClickBina handyman price list — TV wall mounting price row (bracket excluded, concealed cabling extra).
  • ClickBina wall plugs and anchors guide — wall types, bracket leverage, AAC and plasterboard advice, drilling safety, condo hours.
  • ClickBina TV cabinet cost guide — Vogel's installation manual statement and the plasterboard fixing rating, as quoted there from the makers' documents.
  • ClickBina false wall cost guide — backing board behind a TV bracket point.
  • ClickBina TV cabinet size guide; TV and Astro cabling guide; TV feature wall cost guide; wall hole patching guide.
  • How we priced it: every RM figure is quoted unchanged from the ClickBina guides named (indicative Klang Valley, 2026).

Ready to get it sorted?

WhatsApp us your job details for a quote — we reply within the hour. A site visit is free. We serve KL, Selangor & Putrajaya.

💬 WhatsApp for a quote
Reply within the hourFlat price, no hidden chargesExperienced KL & Selangor contractor

Common Questions

How much does it cost to mount a TV on the wall in Malaysia?
ClickBina's handyman price list puts TV wall mounting at RM80 to RM200 (indicative 2026, Klang Valley), with the bracket excluded and concealed cabling extra.
Can I mount a TV on a plasterboard wall?
Not on the board alone. The bracket must be fixed through to the studs or the structure behind, or to backing such as plywood fixed in before the board went up. Otherwise put the TV on a solid wall or a console.
Is a TV stand or a wall mount better?
A wall mount saves floor space and keeps the TV out of children's reach; a stand is simpler on a weak wall and leaves no holes in a rented home.
How high should a wall-mounted TV be?
Keep the middle of the screen close to your eye level when seated. Mark the outline with tape and check it from the sofa before drilling.
Which bracket type should I choose?
A fixed bracket for a TV straight opposite the sofa, a tilting bracket if it sits a little higher, and a full-motion arm for corner seating, on a strong wall only, because it puts the most leverage on the fixings.
How are the cables hidden when the TV is on the wall?
With surface trunking, with conduit cut into the wall and plastered over, or inside a false wall. Plan the power and data points behind the screen before mounting.
What happens to the wall when the bracket is removed?
The holes are filled and the area skimmed on masonry, or a damaged section of gypsum board is cut out and patched, then primed and painted.

Free Quote

Tell us what you need — we reply within the hour.

WhatsApp ClickBina← All Guides
💬 Get Your Free Quote